Újezd u Brna
Mon - Fri 8 - 11 a.m., 12 - 15 p.m.
bank transfer and cash on delivery.
It is not possible to pay by card!
in the case of pallet consignments
according to contract
Clamping screw with lever GOLEM II (0130204)
The base arm is used to attach the system to a wall or a vertical pipe of different diameters. It is possible to attach to the base arm a center and then an end arm, as required by the customer, to form a two-arm assembly.
If necessary, the center arm can be omitted and the end arm can by connected directly to the base arm. So a single-arm assembly is produced.
The center and end arm can be selected in two variants:
250 mm or 350 mm long. By combination of these parts, the suspended device can be offset from the vertical structure in the following lengths: 400 mm, 650 mm, 750 mm
and 850 mm.
To the end arm can be attached one of the parts used to fix the luminaire or other device. The choice is T-holder, Disc holder, and Suspension device with pin, Insert with screw.
The total load capacity of the two-arm assembly is 50 kg
· Solid steel structure
· Modular design of the whole system
· Total load capacity of 50 kg
Example 0130104 + 0130105
|560 kB||Katalogový list|
|91 kB||Prohlášení o shodě|
|549 kB||Product Data Sheet|
|80 kB||Declaration of Conformity|
For pipe 30-43 mm. This element is part of the GOLEM II modular carrier and mounting system. Total load capacity of 50 kg.
End arm with hole length 250 mm, without pin. This element is part of the GOLEM II modular carrier and mounting system.